3
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
COMPRESSED AIR REQUIREMENTS
Use only clean, dry, regulated compressed air as a power source.
Air compressors used with the tool must comply with the appropriate
European Community Safety Directives.
A build-up of moisture or oil in the air compressor will accelerate wear and
corrosion in the tool. Ensure any moisture is drained from the compressor daily
and the inlet filter is kept clean.
If an unusually long air hose is required, (over 8 metres), the line pressure or the
hose inside diameter may need to be increased.
The air hose must be rated at least 150% of the maximum operating pressure of
the air tool.
A typical air line layout is shown above. If an automatic in-line filter/regulator is
used, it will keep the air tool in good condition, but should be regularly
checked.
For optimum performance it is recommended that a 3/8” ID hose is used.
DO NOT exceed the maximum operating pressure. It is recommended that air
pressure does not exceed 90 psi (6.2 bar). Higher pressures and dirty air will
shorten the life of the blow gun due to faster wear and is a possible safety
hazard.
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF
COMPRESSORS AND COMPRESSED AIR.
Содержание CAT210
Страница 8: ......
