6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
only when the drain malfunctions or is being replaced with an optional
automatic drain.
CLEANING
1. Clean all parts with warm water and soap.
2. Rinse and dry the parts. Blow out internal passages in the body with clean,
dry, compressed air. Blow air through the filter element from inside to
outside to remove surface contaminants.
3. Inspect all parts and replace any found to be damaged.
ASSEMBLY
1. Lubricate the O-rings, the portion of the manual drain body that contacts
the bowl, and the hole in the manual drain body that accommodates the
stem of the drain valve with O-ring grease.
2. Assemble the filter as shown on page 7. Place the O-ring on the louver,
then press into place in the body. Screw the baffle on the center post until
contact is made with the filter element, then tighten an additional 1/4 turn.
3. Assemble the Sight glass kit (Ref. No.6) to the bowl. Apply a gentle
clamping force to the upper and lower sigh glass brackets to pull the
brackets together, then tighten the screws per the table below.
4. Tighten these parts listed in Torque Settings table.
5. Twist the bowl into the body until the arrowhead is in line with or to the right
of the arrowhead on the body.
ACCESSORIES
A wide range of accessories is available including filter/regulators, lubricators,
high-pressure hoses (5 to 50 metres) etc.
Contact your CLARKE dealer for further information or CLARKE International
Service Department.
Torque Settings
Part
Inch Pounds (N-m)
Screw
8 to 10 (0.9 to 1.13)
Nut
20 to 25 (2.3 to 2.8)
Содержание CAT187
Страница 8: ......
