6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
DISASSEMBLY
The filter can be disassembled without removal from air line.
1. Shut OFF the inlet pressure and
reduce pressure in the inlet and
outlet lines to zero.
2. Remove the bowl. Push into the
body and turn anti-clockwise.
3. Disassemble in general
accordance with the parts
illustrated. Do not remove the
drains or the service indicators
unless replacement is necessary.
Remove and replace only if they malfunction or if converting to auto drain.
CLEANING
1. The element cannot be cleaned. Clean the polycarbonate bowl with
warm water only. Do not submerge service indicator in water. Clean
indicator with a dry, clean cloth. Clean other parts with warm soapy water.
2. Rinse and dry the parts. Blow out internal passages with clean, dry,
compressed air.
3. Replace any parts found to be damaged. Replace the plastic bowl with a
metal bowl if the plastic bowl shows signs of cracking or cloudiness.
ASSEMBLY
1. Lubricate the o-rings, the portion of the manual drain body that contacts
the bowl, and the hole in the manual drain body that accommodates the
stem of the drain valve with o-ring grease.
2. Assemble the filter as shown on page 7. The arrows on the indicator and
body must point in same direction. Torque values are listed below.
Torque Settings
Part
Inch Pounds (N-m)
Screw (a)
17 to 22 (1.9 to 2.5)
Element
5 to 20 (0.5 to 2.3)
Screw (b)
25 to 35 (2.8 to 3.9)
Nut
20 to 25 (2.3 to 2.8)
Содержание CAT181
Страница 8: ......