Clarke CAT116, Инструкция по эксплуатации и техническому обслуживанию, Страница: 9 / 12

9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
MAINTENANCE
DAILY
• Drain water from air tank, air line and compressor.
• Pour a few drops of CLARKE air line oil, into the air inlet. This should be
carried out regardless of whether or not an air line lubricator is used.
If an air line lubricator is not used, this procedure should be repeated
after every two to three hours of use.
WEEKLY
• Check the air inlet screen filter and clean if necessary.
• Remove the grub screw and
insert a few drops of oil into the
oil port on the side of the air
drill.
CLEANING
• Keep the body of the air drill
clean and free from debris, grit
or gum deposits in the tool may
reduce efficiency.
SERVICE AND REPAIR
• All servicing and repair must be carried out by qualified service
technicians.
NOTES
• Please note that factors other than the tool may effect its operation
and efficiency such as reduced compressor output, excessive drain
on the airline, moisture or restrictions in the line, or the use of
connectors of improper size or poor condition which will reduce air
supply.
• **Clarke air line oil (part no. 3050825) is available from your CLARKE
dealer.
WARNING: MAKE SURE THAT THE AIR DRILL IS DISCONNECTED FROM THE
AIR SUPPLY BEFORE STARTING ANY CLEANING, OR MAINTENANCE
PROCEDURES.
Grub
Scre