7
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
12.
Accessories. Only use the recommended accessories.
Ensure that the
wheels and discs are fitted in accordance with the manufacturer’s
instructions.
13.
Only use discs that comply with EN12413 or EN13236.
Make sure that the
disc used is suitable for the no load speed of the angle grinder. See
Specifications on page 16. Check that the speed marked on the wheel
dimensions are compatible with the grinder. Check that discs are
specifically for hand held angle grinder use.
14.
Sparks and particles.
Ensure that sparks and particles resulting from use do
not create a hazard, Use screens where appropriate.
15.
Personal protective equipment.
Always use protective safety glasses and
hearing protectors. Use other protective equipment such as gloves, apron
and helmet where necessary. If working at floor level, always wear knee
pads.
16.
Switching off.
The disc will continue to rotate for a few seconds after the
angle grinder is switched off. Always wait until the disc has completely
stopped before putting the angle grinder down.
17.
Use the disc guard.
Do not use the angle grinder without the disc guard.
Make sure that the guard is securely fitted and positioned for maximum
safety before operating the angle grinder. Always use the correct guard for
cutting or grinding work as described in this manual.
18.
The grinding surface of depressed centre wheels must be mounted below
the plane of the guard lip
. An improperly mounted wheel that projects
above the plane of the guard lip cannot be adequately protected.
19.
Holding the angle grinder.
Always hold the angle grinder with both hands.
Ensure that the workpiece is kept at waist height where possible. Never use
the angle grinder between the legs whilst sitting on the floor.
20.
Feed direction.
For cutting, always feed the disc into the work so that an
upcutting action is achieved.
21.
Spindle lock.
Do not operate the spindle lock while the spindle is still
spinning.
22. Always take care to avoid kickback by maintaining a firm grip of the tool
and positioning your body and arm to resist kickback forces. Always use
the auxiliary handle for maximum control.
23. Never position your hand close to the rotating parts and take special care
when working in corners or with sharp edges, or any situation where the
disc could snag.