TROUBLESHOOTING
Problem
Possible Cause
Remedy
Tool will not operate 1. No Supply
1. Check Supply and rectify
where necessary.
2. Switch is faulty
2. Consult your Clarke dealer
3. Brushes badly worn
3. Check and replace if
necessary
4. Fuse blown
4. Check and replace if
necessary. If condition
persists, consult your dealer
5. Motor faulty
5. Consult your Clarke dealer.
Motor runs but disc 1. Flange nut not tight
1. Tighten flange nut
will not
2. Gear shaft or key
2. Consult your Clarke dealer
broken
Heavy internal
1. Faulty motor
1. Consult your Clarke dealer
Sparking
2. Badly worn Brushes
2. Renew brushes (see p.7)
Motor gets hot
1. Work load too heavy
1. Reduce force applied to tool
2. Low supply voltage
2. Ensure supply voltage is
correct. If extension cable is
used, ensure it is of the
correct value, and is fully
unreeled
Excessive vibration
1. Wheel not mounted
1. Check and rectify
correctly
2. Bearings worn
2. Consult your Clarke dealer
8
This product conforms with the following directives:
73/23/EEC and 89/336/EEC
