8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
FITTING THE HANDLE
The CAT137 is supplied with an
auxiliary handle. To install it proceed
as follows.
1. Slide the clamping ring over the
body of the drill., ensuring it rests
on the flat shoulder provided.
2. Screw the handle onto the
threaded part of the clamping ring
until the handle assembly is tight.
• The handle can be located at
any position around the drill by loosening the handle grip and
adjusting the position.
INSERTING/REMOVING THE DRILL BIT
1. Open the chuck jaws by gripping
the lower part of the chuck and
turning the upper part counter-
clockwise by hand.
• The direction of twist is
embossed on the upper chuck
body.
2. Place the drill bit in the jaws of the
chuck as far as it will go.
3. Close the chuck jaws and tighten
to grip the drill bit by turning the upper chuck clockwise by hand while
holding the lower part.
4. Make sure that the chuck jaws are fully closed and that the drill bit is held
firmly.
5. Your air drill is now ready for use.
Содержание air CAT137
Страница 16: ......
