Clarke air CAT108, Инструкция по эксплуатации и техническому обслуживанию

Страница: 8 / 16

8
MAINTENANCE
WARNING! Make sure that the ratchet wrench is disconnected from the air
supply before starting any cleaning or maintenance procedures.
DAILY
• Drain water from the compressor air
tank and air-line.
• Pour a few drops of CLARKE air line
oil**, into the air inlet. This should be
carried out regardless of whether or
not an air line lubricator is used. If an
air-line lubricator is not used, this
procedure should be repeated after
every two to three hours of use.
WEEKLY
• Check the air inlet screen filter shown
in Fig 4 and clean if necessary.
CLEANING
• Keep the body of the tool clean and free from debris. Grit or gum deposits
in the tool may reduce efficiency.
• After extensive use, remove the inlet screen filter and flush out the
mechanism with gum solvent oil or an equal mixture of SAE No10 oil and
paraffin. Allow to dry before use.
SERVICE AND REPAIR
• Any major servicing and repairs should be carried out by your local
CLARKE dealer.
PERFORMANCE
Please note that factors other than the tool may effect its operation and
efficiency such as reduced compressor output, excessive drain on the airline,
moisture, or restrictions in the line, or the use of connectors of improper size or
poor condition which will reduce air supply.
**Clarke Airline Oil is available from your CLARKE dealer part no. 3050825.
ACCESSORIES
A wide range of accessories are available including filter/regulators,
lubricators, high pressure hoses, etc. Contact your CLARKE dealer for further
information, or call CLARKE International on 01992 565333.
Air Inlet Screen
Filter (located
here)
Fig 4