7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CAUTION: SHOULD ANY ABRASIVE BE SPILLED, ENSURE IT IS CLEANED UP
IMMEDIATELY, AS ITS SLIPPERY PROPERTIES CAN BE EXTREMELY HAZARDOUS.
REPLACING THE ABRASIVE NOZZLE
Ensure the air supply is disconnected before performing this operation.
1. Pull the trigger of the gun as a precautionary measure.
2. Unscrew the end cap and withdraw the ceramic nozzle.
3. Replace with the nozzle of your choice and carefully thread the end cap
back on to the gun, taking great care NOT to cross thread the fine thread.
NOTE:
Should it be necessary to change the air nozzle, first remove the
abrasive nozzle as described above. A box spanner will be
required to unscrew and withdraw the air nozzle.
MAINTENANCE
Before use, check to ensure that all parts are serviceable, including the air
inlet hose, rubber gloves. and abrasive pick up.
The door securing clamp must be perfectly serviceable so as not to allow the
door to open during operation. The build up of air pressure within the cabinet
could force the door open, allowing abrasive to escape. This is not only
wasteful, but could be a health hazard.
Change the window protective film should visibility be impaired. Simply peal
off the old film and replace with a new one. Replacement protection film is
available from your Clarke dealer.
Содержание 7640115
Страница 1: ...USER INSTRUCTIONS GC0116 SAND BLAST CABINET MODEL NO SB30 PART NO 7640115 ...
Страница 12: ......