Clarke 7623055, Инструкция по эксплуатации и техническому обслуживанию

Страница: 7 / 13

7
OPERATION
POSITIONING
Ensure the load is chocked and stable and on firm level ground.
1. Release the handle lock as shown on the right.
2. Turn the release knob counterclockwise, to lower
the lifting ram
3. Position the jack so that the saddle is directly
beneath the lifting point and that there are no
obstacles to prevent a clean lift, also, make sure
that all personnel are well away from the area,
before raising the vehicle.
TO LIFT
1. Close the release valve by turning the release
knob clockwise firmly.
2. Operate the jack by pumping the jack handle or foot pedal
• Make sure that the saddle is in full contact with the lifting point and that
there are no obstacles to prevent a clean lift.
3. Place axle stands beneath the vehicle.
• Ensure the axle stands are centred about the support point and
perfectly stable before full weight is taken.
• Ensure that the axle stands are in good condition and fully capable of
supporting the load.
• Ensure that the axle stands cannot move when supporting the load.
• DO NOT jerk the handle, ensure it lowers slowly and under complete
control on to the axle stands which must be correctly positioned and
take the weight evenly.
TO LOWER
1. Lift the vehicle slightly to remove the weight from any supports,
2. Remove any supports from beneath the vehicle.
3. Open the release valve by SLOWLY turning the release knob counterclockwise.
NOTE:
Ensure this operation is carried out under complete control. DO NOT
allow the load to drop suddenly as this could damage internal
components.
4. Remove the jack from beneath the vehicle.
NOTE:
The jack may move slightly during operation. It is important therefore
that the immediate vicinity is clean and completely free from debris.