8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PREPARATION FOR USE
PURGING THE HYDRAULIC SYSTEM
1. Insert the pump handle into the
actuating lever.
2. Open the release valve by turning
anti-clockwise.
3. Pump several full strokes to
eliminate any air bubbles from the
system. Use either the handle or
the foot pedal.
4. Close the release valve by turning
clockwise.
POSITIONING THE RAM
1. Slide the carriage along the cross-
beam.
2. Lock it in position with the four
sprung locking bolts.
IMPORTANT: Always position the ram
directly above the workpiece.
POSITIONING THE PRESSING BED
IMPORTANT: Due to the weight of the press bed, we recommend that you
get assistance from another person when adjusting the bed height.
1. Position the pressing bed so that it
will be as close as possible to the
ram when the workpiece is
mounted on it.
2. Raise one side of the bed and
insert a bed supporting pin into
the next locating hole.
3. Repeat at the other end to level
the bed.
Содержание 7615201
Страница 20: ......
