17
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4. Replace the drain plug and its ring
seal.
5. With the power washer in a level
position, fill to the centre of the
sight-glass with the
recommended oil.
6. Replace the oil filler cap.
ENVIRONMENTAL PROTECTION
One of the most damaging sources of pollution is oil. DO NOT throw away
used oil with your domestic rubbish or down drains and sinks. Place it in a leak
proof container and take it to you local waste disposal site.
CLEANING THE NOZZLE
If the nozzle becomes partially clogged or restricted by dirt or other foreign
material, excess pump pressure may develop. Clean the nozzle immediately
by following the instructions below.
1. Shut off the power washer and turn off the water supply.
2. Pull the trigger on the gun handle to relieve any water pressure.
3. Disconnect the spray wand from the gun.
4. Remove any obstructions and back flush with clean water.
5. Direct the water supply into the spray wand end for 30 seconds to back
flush loosened particles.
6. Reconnect the spray wand to the gun and turn on the water supply.
CLEANING THE WATER INLET
This water inlet should be checked
regularly and cleaned if necessary.
Содержание 7330362
Страница 28: ......
