8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
This pump should require no maintenance other than regular cleaning.
If the pump starts to show signs of wear or damage, contact your CLARKE
dealer for advice. Do not use the pump if there is any damage to the mains
supply cable, or to the float switch or its cable.
CLEANING
1. Check the pump installation regularly to ensure the water inlet is clear of
leaves or other debris.
2. Take extra care to remove any debris from around the impeller.
NOTE:
Do not attempt to repair the pump yourself, as you may damage the
waterproof seal and invalidate your guarantee. Repairs must be
carried out by your CLARKE dealer, or contact the CLARKE Service
Department, on 020 8988 7400.
Note that the pump is fitted with an automatic thermal overload protection
device. If the pump overheats due to an obstruction in the pump, or pumping
warm water in excess of 35
o
C for example, it will shut off automatically. Switch
the pump OFF and disconnect from the mains supply. Check for blockages
and allow the motor to cool (at least 15 minutes) before attempting to restart.
NOTE:
If the pump becomes badly clogged, back flush by removing the
outlet hose adapter and directing a jet of clean water through the
outlet port.
STORAGE
When the pump is not being used for extended periods, clean and dry it
thoroughly and store in indoors. if the pump is left in water, it should be run at
least once a week to prevent it from seizing up.
WARNING: BEFORE CHECKING THE CONDITION OF THE PUMP, ENSURE IT
IS UNPLUGGED FROM THE MAINS SUPPLY. IF THE UNIT IS HARD WIRED,
ENSURE THE CIRCUIT BREAKER IS OPEN.
Содержание 723100
Страница 12: ......