17
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8. When completely satisfied that
the setup is correct, lower the
chuck guard into position and
switch the machine on by pushing
the ‘I’ button. To switch off, push
the ‘O’ button, see Fig 18.
9. During use, the emergency stop
button will drop down over the
other buttons. To stop the
machine instantly, just strike the
red button. To re-start, un-clip and
lift the hinged stop button/cover to access the regular start/stop buttons.
NOTE:
As a safety feature, the ON/OFF switch is a ‘No Volt Release’ type.
Therefore, if the power is interrupted whilst the machine is
switched ON, it will not automatically start when power is restored.
10. Slowly turn the feed handles to bring the drill bit down towards the table
and into your workpiece. Ease the drill bit back up to clear swarf away as
required. After drilling, release the feed handles slowly to return the
machine to its starting position.
WORKING LAMP
The CDP502F is fitted with a working
lamp underneath the head
assembly.
1. Turn it on/off as required by
pressing the button on the front of
the machine.
• The bulb is a screw-in E27 type
obtainable from any hardware
store.
OVERLOAD PROTECTION
A thermal overload device is fitted to
protect the internal machine
components should undue load be
encountered. Should the drill press
stop while in use, for example, if the
drill bit should bind excessively, the
overload device will trip.
Wait a few minutes while the
machine components cool down
before pressing the re-set button
shown.
Содержание 6505592
Страница 28: ......
