15
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING THE BELT
The work stop must be in place when
using the belt horizontally.
1. Secure using the bolt and flat
washer as shown.
2. Ensure a gap of no more than
2mm exists between the belt and
the work stop.
3. The belt can be used in the
vertical position as shown. In this
case, the work stop should be
removed. Lock the belt frame in
the upright position using the arm
locking bolt shown on page 13.
The belt is used for long workpieces,
as shown. The workpiece is driven
against the work stop by the action
of the belt.
• DO NOT exert too much
pressure - a light touch is all that
is required.
• Curves may be sanded as
shown.
4. Let the sander do the work and
ensure the workpiece is flat on the
table surface. Never apply heavy
pressure as this will not only
produce an uneven finish but will
overload the motor causing it to
burn out.
5. On very uneven surfaces or when removing layers of paint, start with a
coarse grit. On other surfaces, start with a medium grit. In both cases,
gradually change to a fine grit for a smooth finish. Regularly check the
condition of the sanding belt or disc and replace it when necessary.
Содержание 6500421
Страница 24: ......
