11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10. Locate the hold down post in its
housing in the stem with the flat
facing the grub screw shown.
Tighten the grub screw, using the
hex. key provided.
11. Slide the fence stem into the
housing in the base of the unit,
then screw in the locking lever into
the housing and use to secure the
fence.
12. Lower the Hold Down on to the
post and secure temporarily by
tightening the locking lever.
NOTE:
If the locking lever is
prevented from turning, pull
the handle outwards against
spring pressure, then turn the
handle to a more convenient
position. Release the handle
to lock it in place and
proceed to turn the
complete assembly once
again. Repeat the process as
necessary until the lever
assembly locks the device in place.
13. Finally, attach the tool holder to the
machine as shown. Two hex. socket
head screws are provided for this
purpose.
INSTALLATION
IMPORTANT: Before using the machine, it
must be bolted down to a firm and stable
workbench to prevent it from tipping during
operation. Two holes are supplied in the
base for this purpose.
Additionally, the chisel and bit must be
installed and various adjustments made
before the machine can be used. These
procedures are described on the following pages.
Содержание 6500015
Страница 24: ......
