
11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
• Make sure that the flat
sided spindle lines up with
the groove in the wheel
base.
8. Replace the head assembly
and screws.
NOTE:
Replacement grinding
stones can be
purchased via the
CLARKE International
Parts & Service department (see bottom of page).
CLEANING
1. Keep the surface of your sharpener free of grit, dirt, and grease. Use a
damp soapy cloth or non-toxic solvents and regular wipe down the
grinding stone assembly.
2.
DO NOT
use petroleum based solvents.
3. Keep the air vents free of foreign matter at all times by using an air duster.
4. If the motor does not operate, it may need to be serviced or replaced by a
qualified technician.
TROUBLESHOOTING
If the motor turns on, but the grinding wheel does not spin, make sure the
adjustment cylinder's inner flat sided spindle lines up with the outer flats of the
spindle as described in Changing the Grinding Stone on page 10/11.
Error/Fault
Cause
Remedy
Tool does not work
No power supply
Check the cable, plug
and the fuse and
replace where
necessary.
Insufficient Sharpening
Performance
Grinding stone too worn Replace the grinding
stone (see page 10)
Содержание 6480231
Страница 16: ......