Clarke 6480210, Инструкция пользователя

Страница: 8 / 12

8
SETUP AND OPERATION
BEFORE plugging into the mains supply briefly pull the trigger and release to ensure the drill
trigger lock is not set in the ‘lock’ position.
Using the Chuck:
To insert a drill bit, open the chuck jaws by rotating the chuck sleeve anticlockwise
until the jaws are open sufficiently to take the drill bit. Place the drill bit in the jaws of
the chuck as far as it will go. Insert the chuck key in one of the three holes in the
chuck and turn in a clockwise direction. Make sure that the head of the chuck key is
located on the cog barrel of the chuck when tightening.
Remove the chuck key before operating the drill.
To remove the bit, release the jaws by inserting the chuck key in one of the holes and
turning in an anticlockwise direction.
To Switch on:
Plug into a 13amp socket and squeeze the trigger.
Continuous Operation:
Squeeze the trigger and lock by pressing the trigger lock button, squeeze the trigger
again briefly to unlock the trigger. The motor will then stop.
Speed Selection:
The speed is varied by applying more or less pressure on the
trigger. The maximum speed may be pre-selected by turning
the variable speed control and by selecting one of the two
speeds on the speed selection knob (turn the knob until the
number is aligned with the arrow on the drills’ body).
NOTE: This operation should only be performed when the drill is
at a complete stop.
1
2
3
4
5
6
7
8
1. Trigger
2. Variable Speed Control
3. Forward/Reverse Control
4. Trigger Lock Button
5. Speed Selection
6. Drill/Hammer Drill Selection
7. Chuck
8. Auxiliary Handle