8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
IMPORTANT: To avoid accidental starting, ensure the drill is switched OFF
before plugging in to the mains. To do this, briefly pull the switch, and
release to ensure the trigger lock is not set in the ‘lock’ position.
INSERTING A DRILL BIT
1. Open the chuck by rotating the
chuck sleeve anticlockwise until
the jaws are open sufficiently to
take the drill bit.
2. Place the drill bit in the jaws of the
chuck as far as it will go.
3. Insert the chuck key in one of the
three holes in the chuck and
tighten in a clockwise direction.
• Make sure that the head of the
chuck key is located on the cog barrel of the chuck when
tightening.
• To remove the bit, release the jaws by inserting the chuck key in one
of the holes and turning in an anticlockwise direction.
SWITCHING ON & CONTINUOUS OPERATION
1. Plug into a 13amp socket and squeeze the trigger to start the drill.
2. During use, press the trigger lock-on button and the drill will run
continuously. Squeeze the trigger again briefly to release the trigger lock &
stop the drill.
WARNING: TAKE CARE TO REMOVE THE CHUCK KEY BEFORE OPERATING
THE DRILL.
Содержание 6479504
Страница 16: ......
