9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
2. When sanding wood, always sand in the direction of the grain,
• Do not exert pressure on the sander.
• Regularly check the condition of the abrasive accessory and replace
when necessary.
• On very uneven surfaces or when removing layers of paint, start with a
coarse grit. On other surfaces, start with a medium grit. In both cases,
gradually change to a fine grit for a smooth finish.
MAINTENANCE
GENERAL CARE
Your sander has been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation depends upon
proper care.
1. Regularly clean the ventilation slots using a soft dry brush or dry cloth.
2. Only clean the motor housing using a clean damp cloth. Do not use any
abrasive or solvent-based cleaner.
A damaged power cable should be replaced by your Clarke dealer or a
qualified electrician.
The bearings in this sander are sealed for life and require no maintenance.
If the sander should become too hot, run it for 2 minutes without load.
Any worn or damaged parts should be replaced by qualified personnel. Keep
the handles clean and free from oil and grease. Refer to qualified service
personnel if internal maintenance is required.
CHANGING THE CARBON BRUSHES
1. With a suitable screwdriver, remove the carbon brush caps on either side of
the motor housing.
2. Remove the carbon brush/spring assembly.
3. If the carbon brushes are worn down to 4mm or less, replace them with
new brushes. Replace the carbon brush caps and tighten them.
NOTE:
Both brushes must be replaced at the same time.
WARNING: MAKE SURE THAT THE BELT SANDER IS SWITCHED OFF AND
DISCONNECTED FROM THE MAINS SUPPLY BEFORE STARTING ANY
CLEANING OR MAINTENANCE PROCEDURES.
Содержание 6462050
Страница 12: ......
