Clarke 6462011, Инструкция по эксплуатации и обслуживанию

Страница: 8 / 11

8
TROUBLE SHOOTING
Sander Is Overheating
This indicates the machine is dirty. Clean the ventilation holes, and blow out with compressed
air or clean with a dry cloth.
Overloading the machine will also cause overheating. Do not use for heavy duty work, and
do not apply excessive pressure.
Excessive Sparking Occurs
This indicates worn brushes. This problem is quickly remedied but you should consult your
CLARKE dealer for parts and advice.
Sander Does Not Operate When Switched ON
Check to ensure the fuse is sound and replace if necessary. If the fuse is sound or blows
repeatedly, consult your CLARKE dealer.
The Dust Is Not Extracted
Dust bag is full (empty waste bag), dust extractor flue is blocked, this is usually caused by
allowing bag to become too full, (remove and empty bag, also clear blockage).
Note :
Ensure sander is switched OFF and isolated from the mains by removing plug from socket.
MAINTENANCE
WARNING!
Make sure that the sander is switched off and disconnected from the mains supply before
starting any cleaning or maintenance procedures.
After use clean out any accumulated dust or chippings etc. Keep the cooling vents
clear. If the sander should become too hot, run it for 2 minutes without load.
Clean the housing with a soft cloth. Any worn or damaged parts should be replaced by
qualified personnel. Keep the handles clean and free from oil and grease. There are no
user serviceable parts inside this sander. Refer to qualified service personnel if internal
maintenance is required.
ACCESSORIES
A wide range of accessories is available from your nearest CLARKE dealer, for further
information, contact your nearest dealer, or telephone CLARKE International Sales
department on 01992 565300