7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3. Line up the holes in the disc with those on the machine sanding pad. (This is
necessary for dust extraction purposes). Press the disc firmly onto the pad
to secure it.
FITTING THE HANDLE
Your sander is fitted with an adjustable support handle. This can be adjusted
for position by loosening handgrip lightly, (unscrew anticlockwise) and rotating
the handgrip around the body of the machine to the desired position, then
tightening securely.
DUST COLLECTION
The dust collection bag is fitted by inserting the holder into the waste duct
below the ON/OFF switch.
The dust bag must be emptied regularly:- do not wait until it is completely full.
The dust bag is emptied as follows.
1. Ensure the sander is switched OFF.
2. Gently remove the dust bag assy from the sander by turning whilst pulling.
3. Take the dust bag to the dustbin and slip the bag off, (the bag has an
elasticated top), empty the bag into the bin.
4. Reassemble the dust bag assy and fit back on to the sander.
OPERATION
To operate, plug into the mains socket and switch on, holding the sander firmly
with both hands. Squeeze the ON/Off switch located below the handle.
To control the speed, turn the knob located on the switch in the direction
marked, i.e. - = lower speed + = higher speed.
The ON/Off switch can be locked for continuous sanding; to release the
switch, just depress again and release.
Place the disc on the workpiece and switch on, working gently backwards
and forwards across the work until finished. Release the switch, (wait until the
motor has stopped fully before putting the sander down).
