Clarke 4500632, Инструкция по эксплуатации и обслуживанию, Страница: 8 / 16

8
BATTERY CHARGING
1. The new battery pack will require
charging before use.
2. Squeeze the battery release buttons on
either side of the battery pack and pull
gently down to disengage the battery
pack from the machine as in Fig 1.
3. Insert the battery pack into the battery
charger, as shown in Fig 2, noting that it
will only fit one way.
4. Plug the charger into a 230v (mains)
power supply and switch ON.
• The green POWER ON light will
illuminate to show the unit is
connected to the mains supply. The
RED charging light will illuminate and
charging will begin.
• If charging does not take place,
ensure all connections are clean
and free of grease etc.
• If the red charging light will not stay on for more than a few
moments, the battery pack is likely to be defective and it must be
replaced with a new one.
• When charging is complete (typically
after about 1/2 hour), the RED charging
light goes off. The battery pack can be
considered charged and be removed.
The charging time will be dependant
upon the initial state of the batteries.
When charging a new battery pack it
may initially not accept full charge. This is
common & does not indicate a fault. It
can be recharged fully after it has been
discharged a couple of times.
5. After charging, switch off and unplug the
charger from the power supply.
6. Remove the battery pack from the
charger and slide it back into the machine
until it clips into place.
FIG 1
FIG 2