CLARKE TECHNOLOGY Extractor Tools Operator's Manual
Page 5
How To Operate The 8" and 12" Wands
NOTE:
Instructions for preparation and op-
eration of your extractor are given
with the extractor.
CAUTION: Clarke Technology will not be held
liable for damage to the carpet, or
poor results because of operator's
lack of training.
CAUTION:
Do not use water that is hotter
then 140°F.
To operate the 8" and 12" wands follow this procedure:
1.
Connect the vacuum hose to the hose
connector on the extractor and to the end of
the vacuum tube on the floor.
2.
Connect the solution hose to the extractor and
the floor tool. To fasten the quick-disconnect
slide the knurled collar on the female coupling
away from the opening. Push the male
coupling into the female coupling.
3.
The switch that activates the motor for the
pump is on the extractor. Put the switch in
the "ON" position.
4.
The switch that activates the motor for the
vacuum is on the extractor. Put the switch in
the "ON" position.
5.
Move the floor tool to the right-hand corner of
the carpet.
6.
Hold the floor tool at an angel that gives the
best seal between the tool to increase the
seal.
7.
Press down on the tool to increase the seal.
8.
Press the solution release lever.
9.
Move backwards and pull the tool toward you
at a rate of about 30 feet per minute. Move
slower for very dirty areas.
10. Release the solution lever approximately six
inches before you stop moving backward.
11. Lift the wand and move it to the side of the
starting point.
12. To clean the edge of a room, move the wand
along the baseboard.
