9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
OPERATING THE DRILL
1. Squeeze the trigger to start the
drill.
2. Release the trigger to stop the drill.
3. To change the direction of rotation
move the lever behind the trigger
from F to R.
4. Always ensure the drill has stopped
before putting it down.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air supply hose until the air supply has been shut
down and the compressed air released from the hose.
• Refer to the compressor instruction manual for the procedure to shut
down and release the compressed air.
2. Once the pressure has been released, disconnect the air supply hose from
the drill.
MAINTENANCE
Please note that factors other than the drills condition may effect its operation
and efficiency, such as reduced compressor output, excessive drain on the
airline, moisture or restrictions in the air-line, or the use of connectors of
improper size or poor condition which will reduce air supply.
DAILY
1. Before use, drain water from the air-line and compressor.
2. Lubricate the drill daily for optimum performance. Use a high quality airline
oil either via a lubricator in the air supply system or by placing a few drops
into the air inlet immediately before use. This should be carried out
regardless of whether or not an in-line lubricator is used.
WARNING: MAKE SURE THAT THE DRILL IS DISCONNECTED FROM THE AIR
SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE
PROCEDURES.
Содержание 3120172
Страница 16: ......
