8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
INSERTING/REMOVING THE DRILL BIT
1. Open the chuck jaws by inserting
the chuck key in one of the holes
in the chuck and turning it as
shown.
2. Make sure that the head of the
chuck key is located on the barrel
of the chuck.
3. Turn the chuck key until the chuck
jaws are open sufficiently to take
the drill bit.
4. Place the drill shank into the jaws
of the chuck.
5. Close the chuck jaws and tighten
to grip the drill bit by turning the
chuck key as shown.
6. Make sure that the chuck jaws are
fully closed and that the drill bit is
held firmly.
7. Your air drill is now ready for use.
OPERATING THE AIR DRILL
1. Squeeze the trigger to start the drill.
• Lightly position the drill bit on the workpiece and gently squeeze the
trigger.
• Once the drill is cutting and up to speed, apply a steady pressure to
drill into the workpiece.
2. Release the trigger to stop.
3. Always ensure the drill has stopped before putting it down.
WARNING: MAKE SURE THAT THE CHUCK KEY HAS BEEN REMOVED
BEFORE USING THE DRILL.
Содержание 3110881
Страница 16: ......
