8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PREPARATION & ADJUSTMENT
CHECKING THE OIL LEVEL
1. Disconnect the riveter from the air
line.
2. Hold upside-down and remove the
air cylinder cap (fig 1) with the
spanner provided.
3. Remove the air/hydraulic piston
assembly (grip the exposed nut
and pull up) as in Fig 2.
4. Add hydraulic oil to the hydraulic
cylinder until the level is just below
the connection with the air
cylinder. See fig. 3.
5. Lightly lubricate the inner wall of
the air cylinder.
6. Replace the air/hydraulic piston
assembly and press in as far as it
will go.
7. Refit and tighten the air cylinder
cap.
ADJUSTING THE STROKE
1. Check that the hydraulic level is correct as above.
2. Remove the frame head using the spanner provided.
3. Check the jaw stroke by using the
spanner/gauge as in figs 4 and 5.
4. Set the distance to <71mm i.e. the
length of the spanner gauge as
shown.
