8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
If the compressor has not been used for 24 hours or more, open the drain valve
in the tank to drain any condensate which may have accumulated. See
page 10
1. Insert the plug into the power socket and switch on the power.
2. Lift the On/Off button.
• The compressor will run until the
main tank is fully pressurised. It
will then switch off.
• The compressor will start up
again when the pressure in the
main tank decreases during
use.
3. Make sure the safety valve is
working correctly by pulling on the
ring attached.
• Air should be released when the
ring is pulled and stop when
released.
• If the valve does not operate as
expected, it must be replaced
by qualified service personnel
before the compressor is used.
4. Set the operating pressure you
need using the pressure regulator.
• Clockwise to increase the
pressure
• Anticlockwise to decrease the
pressure
WARNING: DO NOT REMOVE OR ATTEMPT TO ADJUST THE SAFETY VALVE.
