Clarity SN-4035-WX Bobcat, Руководство пользователя

Страница: 42 / 120

3.3 Manual Selection and Adjustments
32
3.3.1 Selecting the Picture
3.3.1.1 Auto or Manual Mode Selection
Sometimes the automatic mode selection doesn’t get it right. If this happens, you can force the mode
manually. This works for Analog RGB sources only.
Auto mode selection
• Press
SETUP
to make the Bay Cat automatically
readjust itself to the current picture.
• Press
SOURCE
to make the Bay Cat look for the
next connector with a valid signal.
There are potential problems with any automatic sys-
tem. Sometimes you may switch to another analog
RGB source that is very close to the previous one. Bay
Cat may not detect the difference and use the old
mode.
Manual mode selection
If the Bay Cat has trouble with an analog RGB
source, try forcing the mode manually.
Forcing the mode works only with RGB sources that
have H&V sync. It does not work with composite sync
or sync on green.
First, you must know the mode of the analog RGB
source. Look up this mode in the table, opposite, and
open the Force Analog Mode menu.
1. In the menu, be sure Enable Force Mode is not
checked.
2. Select the Select Mode Number line and use the
+ \ – keys to choose the mode number found in
the table. (See Analog RGB Modes table on
page 94.)
The resolution and vertical refresh rate show in the
menu in the
current resolution, not the resolution of the
mode number. These numbers do not change until you
check Enable Force Mode.
3. Arrow down and press
ENTER
to force the Bay Cat
to use this mode.
Bay Cat will use this forced mode for all analog RGB
sources until this line is unchecked. When
unchecked, the automatic system will start again.