6
XN3210/XN3410
English
Owner’
s Manual
• Output Mode Selector Switch: CH 1/2 and CH 3/4 (XN3410 only)
STEREO:
Full left and right stereo operation.
CH1Mono / CH2 Mono:
Single channel input for bridged operation. This is
especially useful in high-powered systems. (Uses CH2 and CH4 inputs.)
CH1/2 Mono / CH3/4 Mono:
Allows for a stereo input to be summed into a mono
output.
•
CH1/2 FREQ / CH3/4 FREQ (XN3410 only) The CH1/2 crossover frequencies
are adjustable from 55Hz to 550Hz. While CH3/4 crossover frequencies are
adjustable from 55Hz to 5500Hz (via the Frequency Range Multiplier) for a wider
range of crossover points. Use this feature along with your speaker
manufacturer's recommended crossover frequencies to quickly design a more
advanced system.
NOTE: If either of the Crossover Mode Switches is set to OFF, varying the
frequency control will have no effect.
•
CH1/2 Filter / CH3/4 Filter (XN3410 only) A filter is activated by sliding the
CH1/2 and CH3/4 filter switch to either HP = High Pass or LP = Low Pass.
CH1/2 is fully adjustable from 55-550Hz (via CH1/2 Freq) and CH3/4 is fully
adjustable from 55-5500Hz (via CH3/4 Frequency and Frequency Range
Multiplier). Use this feature along with your speaker manufacture's recommended
crossover frequencies to design a more advanced system.
CONNECTIONS FOR POWER AND SPEAKERS
The rear panel of the XN3410 and XN3210 contains power and speaker
connections as shown below.
Fig. 2
XN3410
1
2
7
8
3
4
5
6
4
Ω
BRIDGED
FUSE
+ CH1 –
GND REM +12V
30A
30A
+ CH2 –
4
Ω
BRIDGED
+ CH3 –
+ CH4 –
1. CH1 Speaker Output
2. CH2 Speaker Output
3. Ground
4. Remote Turn-on
5. B12V Input
6. (2) - 30 Amp Fuse
7. CH3 Speaker Output
8. CH4 Speaker Output
XN3210_3410 manual_060410 R2.ind6 6
9/3/2010 8:49:20 AM
