13
Installing the Drive Eye
Before Installation
NOTE
About the Drive Eye Camera Angle Adjustment
The Drive Eye camera is wide angle camera and ready to use in default
setting. However, if the camera is installed on the inside of a vehicle with a
steep windshield (e.g. a pickup truck), it may not aim at the right direction.
You can adjust the camera for the right angle. (Adjustable in 4 levels from
an angle of 25 degrees)
If the camera angle is not right in the procedure 1 (Refer to Page 19),
adjust the angle as follows.
Attention
Please carefully read the following:
• Make sure that you stop the engine and remove the key before installation.
• Install in a well-lit place where you can do so safely.
• Park your vehicle on a flat surface when you install, otherwise you cannot set
the impact sensor properly.
• Make sure that the power supply voltage of your vehicle is DC12V/DC24V.
Otherwise, do not install.
When setting the Drive Eye near a TV antenna or a radar detector, noise
breakout may occur because of radio interference. In that case, set them away
from the Drive Eye to reduce noise.
00DRIVE EYE.book Page 13 Friday, February 8, 2008 3:57 PM