Clarion CZ309E, Руководство пользователя и инструкция по установке

Страница: 13 / 137

24 25
8. INSTALLATION / WIRE CONNECTION
GUIDE
Source unit .................................................... 1
Front panel .................................................... 1
Trim plate ...................................................... 1
Owner’s manual ............................................ 1
Screws M5 × 6 mm ....................................... 4
L-key ............................................................. 2
Rubber cushion............................................. 1
Wire connector ............................................. 1
Remote control unit (with battery) ................. 1
DCP case...................................................... 1
Microphone ................................................... 1
2) Package Contents
3) General Cautions
1. Do not open the main unit body. There
are no user- serviceable parts inside.
If you drop anything into the unit dur-
ing installation, consult your dealer or
an authorized Clarion service center.
2. Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner,
benzine, alcohol, etc. For tough dirt,
apply a little cold or warm water to a
soft cloth and wipe o ff the dirt gently.
CONTENTS
1) BEFORE STARTING ............................................................. 24
2) PACKAGE CONTENTS ......................................................... 24
3) GENERAL CAUTIONS .......................................................... 24
4) CAUTIONS ON INSTALLATION ............................................ 25
5) INSTALLING THE SOURCE UNIT ......................................... 25
6) REMOVING THE SOURCE UNIT .......................................... 27
7) WIRING AND CONNECTIONS.............................................. 28
8) CONNECTING THE ACCESSORIES .................................... 29
1. This set is exclusively for use in cars with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery “–” terminal
before starting. This is to prevent short circuiting
during installation. (Figure 1)
1) Before Starting
Car battery
Figure 1
4) Cautions on Installation
1. Prepare all articles necessary for in-
stalling the source unit before starting.
2. Install the unit within 30° of the hori-
zontal plane. (Figure 2)
3. If you have to do any work on the car
body, such as drilling holes, consult
your car dealer beforehand.
Max 30 °
Figure 2
4. Use the enclosed screws for installa-
tion.
Using other screws can cause dam-
age.
(Figure 3)
Figure 3
Max . 6 mm ( M5 screw )
Chassis Chassis
Damage
5) Installing the Source Unit
1. Place the mounting bracket into the instrument panel, use a screwdriver to bend
each stopper of the universal mounting bracket inward, then secure the stopper.
2. Wire as shown in Section 7.
3. Insert the source unit into the mounting bracket until it locks.
4. Take care of the top and bottom of the outer escutcheon and mount it so that all the
hooks are locked.
Notes:
1. Some car models require special mounting kits for proper installation.
Consult your Clarion dealer for details.
2. Fasten the front stopper securely to prevent the source unit from coming loose.
• Console opening dimensions
(182 mm)
7-3/16"
2-1/8
"
53 mm
Hole
English
Polski
Français
Deutsch
Italiano
Nederlands
Español
Sv
ensk
a
Ελλ
ην
ικός
English
Polski
Français
Deutsch
Italiano
Nederlands
Español
Sv
ensk
a
Ελλ
ην
ικός
Downloaded from Caradio-Manual.com Manuals