2 / 3
Doc ID - 706 • REV 07
Figure 1: Attaching CLIQ devices
Adding the rubber foot covers
If you are placing a CLIQ.connect on the bottom of a stack, use
the four rubber foot covers included to prevent it from sliding.
To add the rubber foot covers:
Peel each foot cover from the paper backing and place
one on each foot on the bottom of the CLIQ.connect.
Connecting devices to the CLIQ.connect
Begin making connections to your other devices. Figures 2
and 3 identify the LED and ports on the front and rear of the
CLIQ.connect. Refer to the documentation that came with each
of your other devices for detailed information about connecting
them to the CLIQ.connect.
To connect the CLIQ.connect:
1. Connect your serial devices to either of the two RS-232
ports using a standard RJ12 cable, or an RJ12 to DB9
cable (included). See Figure 3, item 1 and Figure 4.
2. Connect your IR devices (optional) to the 12-pin terminal
connector (included), and then insert the connector into
the port labeled “IR Outputs.” See Figure 3, item 2.
Note:
When connecting an IR emitter (included), attach
the striped wire to positive (+) and the black wire to
negative (-).
3. Connect your digital I/O devices (optional) to the 8-pin
terminal connector (included), and then insert the
connector into the port labeled “I/O.” See Figure 3, item 4.
When connecting devices, wire it such that ports 1 and 2
share the same12 VDC power and ground and ports 3 and
4 share the same power and ground.
4. Connect relay contacts (e.g., garage door contacts) to the
6-pin terminal connector (included), and then insert the
connector into the port labeled “Relay.” See Figure 3,
item 5.
Figure 2: CLIQ.connect front
(1) LED – Illuminates blue when unit is powered on
Figure 3: CLIQ.connect rear connections
(1) RS-232 (2 ports)
(2) IR Outputs
(3) ClareBus
(4) I/O
(5) Relay
RS-232 port pinouts
If you are using your own RJ12 cable (rather than the one
supplied), ensure your RJ12 cable connector pinouts match
the pinouts on the RS-232 ports shown in Figure 4.
Figure 4: RS-232 ports with pinouts
Configure, test, and deploy a project
Refer to the
Fusion Configuration Tool Administrator Guide
(Doc ID 069) for instructions on creating, testing, and deploying
a project.
RS232
IR Outputs
I/O
Relay
#1
#2
#1
#2
1 2 3 4 5 6
12
vd
c
G
nd
#3
#1
#2
12
vd
c
G
nd
#4
N
C
N
O
C N
C
N
O C
(1)
(2)
(3)
(4)
(5)
RS232
#1
#2