Clare Controls ClareVision CV-M32810-08, Руководство по установке

Страница: 11 / 32

ClareVision Network Video Recorder Installation Guide 7
There are four jumpers (JP1, JP2, JP3, and JP4) on the motherboard, each
corresponding to one alarm output. By default, the jumpers are connected. To
connect an AC load, the jumpers should be removed.
Example:
If you connect an AC load to the alarm output 3 of the NVR, then you must
remove the JP3 jumper.
Using of alarm connectors
To connect alarm devices to the NVR:
1. Disconnect the pluggable block from the ALARM IN /ALARM OUT terminal
block.
2. Unfasten the stop screws from the pluggable block, insert the signal cables
into the slots, and then fasten the stop screws. Ensure the signal cables are
tight.
3. Connect the pluggable block back into terminal block.
Controller connection
To connect a controller to the NVR:
1. Disconnect the pluggable block from the KB terminal block.
2. Unfasten the stop screws from the KB D+, D- pluggable block, insert the
signal cables into the slots, and then fasten the stop screws. Ensure the
signal cables are in tight.