5
USE MODE
Connect the speaker jack (pag.7 n°6-7-8) making att ention to connect it with the right
impedante output (look the speaker output). Connect the power jack (pag.7 n°1) and the
instrument jack (pag.6 n°1).
Ensure the amplifier is turned off before connecting the supply cable.
When powering up your amplifier, first switch to the ‘Standby’ (pag.6 n°16) and leave for two
minutes before switching to the power (pag.6 n°15, this will maximise the life of your valves),
so, switch on the header with the lowest volume master, by the apposite switch. It have to light
on the master led. (pag.6 n°13).
Select the channels by header buttons (pag.6 n°6) o r by footswitch.
The footswitch have to be connected to the rear panel input (pag. 7 n°3); this operation cut
off the panel front buttons.
The turn on of every channel will be pointed out by the light on of the correspondent led
(pag.6 n°3-7).
Adjust the tones and the volumes.
The channel 1 produce a clean sound, it will be regulate with a tweed moonlight control tone
(pag.6 n°5), while the channel 2 is dirty, and its bass frequency (pag.6 n°9), middle frequency
(pag.6 n°10) and treble frequency (pag.6 n°11) are adjustable by a 3 band parametric equalizer.
This feature of channel 3 tone regulation characterized the sound with a new taste.
Every channel have a gain control (pag.6 n°4-8), fo r the adjustment of valves signal saturation.
Every channel have a volume control (pag.6 n°4-12) for let the musician to play with the right
sound mix.
The master volume (pag.6 n°14) is the control of th e output signal.
Note: the channels volumes can be used as regulator of the output signal in send socket, the
master volume can be used as regulator of the input signal in return socket.
The amplifier can be used with headphones, even without connected speaker, by the
headphones insert in frontal panel (pag.6 n°2).
Make attention to the volume when headphones are used, it can damage the hearing and the
amplifier.
WARNING! Switch on standby the amplifier before disconnect the instrument jack.
The amplifier uses a valve circuit with high impedance; considering that the instrument
and his power cable can act as antenna, the apparatus may be affected by near radio
frequency sources, like mobile phones, radio microphones, hf, vhf or uhf transmitter
receivers ecc.
To prevent it, it’s suggested to play without mobile phones and transmitter receivers
nearby the apparatus.
IMPORTANT: Before the power on, connect the power supply cable to an earth
grounded AC respectable in accordance with the voltage and frequency ratings
listed under INPUT POWER on the rear panel of this product.
Содержание Vintage 35 head 2C-S-D
Страница 1: ......
