4.
Place drill in position as shown and
tighten chuck
securely
to auger shaft (104688). Slip U-bolt
(103955) over drill handle and
securely tighten
to bracket (104681) using 2 washers (101081)
and 2 knob handles (103956).
5.
FINAL ADJUSTMENTS
:
Adjust trigger paddle height so that the drill’s trigger can be manipulated fully. You
may need to adjust the side to side movement of the vertical bracket to achieve full
depression of the trigger. Once trigger can be fully depressed by trigger linkage and
paddle, tighten both the shoulder bolt going through the trigger paddle on linkage
assembly to the vertical bracket, and the two bolts holding the vertical bracket in place
to the drill plate.
STEP-2
:
POSITION TRIGGER PLATE DIRECTLY UNDERNEATH
THE ON OFF SWITCH BUTTON AND SECURELY TIGHTEN
SCREW DESIGNATED AS POSTION 2
POSITION 2
SCREW
STEP-1
SECURELY TIGHTEN BRACKET 104681
TO AUGER BODY PLATE
STEP-3
ADJUST LINKAGE HERE AND
TIGHTEN SCREWS
NOTE:
THIS LINK WILL NEED TO
BE REMOVED WHEN USING A
SHORT BODY DRILL.