Clack Water Specialist CI WS1, Инструкция по установке, эксплуатации и обслуживанию

Страница: 6 / 22

6
2.6 Electrical connection
To connect the power cable you need to firstly remove the
cover then remove the drive bracket assembly by pressing
up on the drive brackets release tabs and pulling towards
you, the drive bracket including software can now be lifted
away to reveal the back plate (fig A.7).
Fig A.7
When the drive plate has been removed, locate the knockout on the
backplate. You can use a punch or a Phillips screwdriver to do this.
(f
ig A.8
)
You can now re install the drive bracket into its original position.
Please make sure that this has been replaced correctly as this
can cause problems at a later date.
Fig A.8
Fig A.9 Fig A.10 Fig A.11
Remove the tabs at the bottom of the strain relief on the back side of the back plate (fig
A.9
).
You can now connect the power cable to the valve and any additional cables that may be
needed for no hard water bypass
(CI only) or micro switch cables through the knockout. After
connecting the cables you can weave the wires through the strain relief (fig
A.10
) and fit the
cover supplied (fig
A.11
)