24
25
UK
UK
EXAMPLE
FOR A 10-MINUTE WATERING CYCLE EVERY DAY AT 6 P.M.:
AUTOMATIC PROGRAMMING
• AT 6 P.M., PRESS THE RED AND GREEN BUTTONS AT THE
SAME TIME TO SET THE OFF MODE.
• PRESS THE GREEN BUTTON.
• WAIT FOR 10 MINUTES.
• PRESS THE RED BUTTON TO STORE THE SETTING.
• TO DISPLAY THE TIME SETTING, PRESS THE GREEN
BUTTON. AFTER 3 SECONDS, THE LED FLASHES ONCE
TO INDICATE ONE 10-MINUTES BLOCK, STOPS FOR
3 SECONDS, THEN FLASHES FOUR TIMES RAPIDLY TO
INDICATE ZERO.
DIRECT PROGRAMMING
• AT 6 P.M., PRESS THE RED AND GREEN BUTTONS AT THE
SAME TIME TO SET THE OFF MODE.
• PRESS THE GREEN BUTTON.
• PRESS AND HOLD THE RED BUTTON.
• AFTER 5 SECONDS, COUNT 10 FLASHES.
• RELEASE THE RED BUTTON TO STORE THE SETTING.
TO DISPLAY THE TIME SETTING, REPEAT THE PROCEDURE
DESCRIBED FOR AUTOMATIC PROGRAMMING.
CONNECTING TO A RAIN SENSOR
THE AQUAUNO PRATICO CAN BE CONNECTED TO A
RAIN SENSOR (CLABER CODE 90915). THE RAIN SENSOR
CUTS OFF THE AQUAUNO PRATICO WATERING PROGRAM
IN CASE OF RAIN, RESTORING IT AUTOMATICALLY
WHEN THERE IS NO MORE WATER LEFT IN THE SENSOR.
THE RAIN SENSOR MUST BE CONNECTED TO THE
TWO SPECIAL ELECTRICAL CONTACTS PROVIDE INSIDE
THE AQUAUNO PRATICO PROGRAMMING UNIT, USING
THE CONNECTOR SUPPLIED WITH THE SENSOR.
THE TWO-WIRE CABLE MUST BE FED IN THROUGH THE
SEAT PROVIDED IN THE BOTTOM OF THE AQUAUNO
PRATICO. BEFORE FITTING THE CONNECTOR, REMOVE
THE JUMPER PLACED OVER THE TWO CONTACTS.
FOR THE CONNECTION DIAGRAM, SEE BELOW.
-
+
+
-
VALVE
BATTERY
SENSOR
CONNECTOR SUPPLIED
WITH THE RAIN SENSOR