Claas QUADRANT 2200, Руководство по ремонту

Страница: 26 / 31

Basic settings for the twine wrap device
203368
1.7 / 10
1 9
3. Turn the flywheel in the direction of the arrow
again, until the crank arms (8) lie against the ram
stops (9). In this position the ram stops (9) must
be at the level of the opening in the crank arms
(8) (a visual check can be made through the
opening in the side of the machinery housing). If
necessary, correct the settings of the spring cylin­
der ( 10).
4. Turn the flywheel again against the machine
direction, until the knotter shaft clutch engages
and the needles are thereby caught up again.
5. Turn the flywheel by hand in the direction of the
arrow, until the red gauge (L) on the baling ram
on the right side of the machine is between the
braces (S). The markings (M) on the needles
must then be at point ( 11) at the level of the
guide (A). This control point can be seen from the
bottom front, in the twine boxes, through the
holes provided for this purpose.
In this position the pulley (R) on the lever ( 12)
must touch the control curve at (S). If necessary,
correct the setting by adjusting the clevis head
(G) on the drawbar ( 13). To make the settings
the needles must be turned again into the bale
chamber. This is necessary in order to relax the
20
spring cylinders ( 10 and 14).
21
If the needles with the marking (M), on leaving the
bale chamber, stand at the level of the guide,
point ( 11), then dimension (B) must be 5_2 mm. If
necessary, correct the setting of the spring
cylinder ( 14) accordingly.
Release the tying cycle and turn the flywheel
by hand in the direction of the arrow until the
needles are standing in the upper area of the
bale chamber.
In this position, dimension (B) must be 0 mm.
If necessary, make the appropriate setting using
the adjusting bolt ( 15).
(Fig. 8, 9, 18, 19, 2 0 and 2 1)
QUADRANT 2 2 00 / 2 2 00 RC