Claas JAGUAR 830, Информация и базовые настройки поля

Страница: 10 / 31

17 18
Opening Feed Rollers
1. Lower the legs on the front attachment and lower
the feeder housing as far as possible.
2. Undo the 13mm bolt and retaining collar to remove the
panel over the drive belt on the RHS of the feeder.
3. Remove the guard over the drive belt on the RHS of the
feeder housing and remove front attachment belt.
4. Undo the 24mm locking bolt underneath the feeder
housing until the hooks become free.
5. Remove the electrical, lubrication and air connections
on the machine RHS and the hydraulic motor
connections on the LHS.
6. Slacken the bolt and swing out the locking unit on
both sides. The Jaguar can now be reversed, leaving
the feeder housing attached to the front attachment.
Make sure the cutting cylinder is not lifted from the cab,
while the feeder housing is removed.
In order to remove the feed rollers, the front
attachment must remain on the front of the feed
rollers and the following steps need to be followed:
1
2
3
4
5 6