00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09
95
5 Prior to initial operation
5.5 Feeder unit
67081
5.5 Feeder unit
79358
5.5.1 Fitting / adjusting the mounting plates
– Observe the general warnings at the beginning of
the Prior to initial operation chapter.
– Bolt down mounting plate (4) hand-tight on both
sides of the machine.
– Fit front attachment.
– Pull out cotter pin at position (A).
– Slide lock pin (2) up into the feeder unit opening of
the machine, using lever (3).
– Secure lever (3) in position (B), using the cotter
pin.
– Slacken off mounting plate (4) and slide it as
closely to the lock pin (2) as possible. Bolt down
mounting plate (4).
89422
5.5.2 Aligning the coupling pin
The front attachment must be parallel with the drive
axle of the machine. To achieve this, the coupling pins
must be aligned.
– Drive the machine with the front attachment fitted
on a flat and level surface.
– Check the alignment. The finger bar must be par-
allel with the ground while the machine stands on
a flat and level surface.
– If necessary, put down the front attachment.
– Slacken off coupling pins (1) and raise or lower
the pins so that the finger bar is parallel with the
ground on a flat and level surface.
DANGER!
The front attachment is not sufficiently
secured.
Death or serious injury.
– Comply precisely with procedure
instructions.
– Check the safe locking of the front
attachment.
9
19523
B
3
A
2
4
10
19525
F
Содержание DOMINATOR 130
Страница 1: ...DOMINATOR 150 140 130 Operator s Manual...
Страница 2: ...67075 O r i g i n a l o p e r a t o r s m a n u a l...
Страница 79: ...00 0293 210 2 BA DOMINATOR 150 140 130 12 09 79 4 Specifications 4 1 DOMINATOR 150 140 130 67080 24771 3...
Страница 388: ...388 00 0293 210 2 BA DOMINATOR 150 140 130 12 09 67075...
