Model XP2F
Installation, Operation, and Maintenance Manual
N-XP2F IOM V1.0-4.5
Page 17 of 35
4.4.2
DPM Setup
4.4.2.1
Valve
Description:
Allows the user to tell the X35 specifics about the valve, pressure sensor locations, and flow
direction that are needed so flow can be calculated.
Figure 4.15
4.4.2.2
Flow
Description:
Allows the user to configure units for flow, number of decimal points to display, and a low
flow cutoff.
Figure 4.16
Valve size may be in US units
(inches) or metric (mm)
Valve body type can be 100-01
(full port), 100-20 (reduced
port), or 100-02 (angled port)
Seat type of valve may be Std
(standard) or KO (anti-cav)
Location of pressure sensors.
May be Boss-Boss (inlet and
outlet ports) or Pipe-Pipe
(upstream and downstream
pipe)
Flow direction is normal or
reverse
Any flow registered that is less
than the low cutoff value is
forced to zero.
