3
6. Optional Grinding Head :
•
A second head (colored red) is available for the
TURBO-SHARP
®
X for electrodes with diameters of
.040“(1.0mm) - 5/32“(4.0mm) - 3/16“(4.8mm) - 1/4“(6.4mm)
ORDER NUMBER:
TS3-HR
CK Worldwide, Inc.
Wheel Retaining Nut
(LEFT-HAND THREADS)
CHANGING THE GRINDING WHEEL
Follow the same
procedure to change
the collet, except
collet nut must be completely
unscrewed in order for the collet to be changed.
These procedures must be followed exactly as they are explained
and illustrated.
CHANGING THE TAKE-OFF SHAFT & COLLET
Very important !!!
Ensure that the wheel is properly
mounted and not crooked.
Spindle
Collet
Collet Nut
Wheel take-off Shaft
Grinding Wheel
Washer
Remove the plug from the electrical socket before doing any mainte-
nance on this machine !
Remove the plug from the electrical socket before doing any mainte-
nance on this machine !
•
Position wrench #15 on the spindle
•
Position wrench #17 on the collet nut
•
Loosen the nut
•
Replace the wheel take-off shaft
•
Tighten the nut
•
Locate and remove the three small set screws in grinder housing
•
Remove grinder housing exposing wheel and shaft assembly
•
Place wrench #17 on the collet nut
•
Place wrench #10 on the wheel retaining nut
•
Remove wheel retaining nut - NUT HAS LEFT-HAND THREADS
•
Remove washer and grinding wheel
•
Install new grinding wheel
•
Replace washer and wheel retaining nut
•
Tighten wheel retaining nut
•
Make sure wheel is level
•
Replace grinder housing (Don‘t force, gently slide housing on
to ensure an easy installation)
•
To obtain a different grinding area on the disc, loosen
the 3 set screws on the base of the head-cover and
rotate the collar to 1,2 or 3. This will allow 3 different
grinding locations on the disc for one particular angle.
