19
In order to set the reader in programming mode, present the valid
“Authentication Card” to the reader as shown. The reader will beep and
start blinking yellow to indicate that it is now in programming mode.
The Reader is in programming mode for 10 seconds. If no other
pro-gramming card is presented within this time, the reader will return
to normal mode. When a reader leaves programming mode it is
indicated by a blinking red LED and a beep.
Note: for above 3.80.04 firmware version, the LED status of authoriza
-
tion mode is yellow and green flash alternately.
BEEP !
Setting the reader in
programming mode
Reading distance
approximately 2 cm.
