Installation and Setup
Please check to ensure your new system arrived with the following parts.
Items Included
l
Four hollow wall anchors and screws for wall mounting the unit
l
One ‘High-Level Disinfectant’ warning label
Note: it is an OSHA requirement that containers holding high-level
disinfectants be clearly marked as such.
l
One ‘Initial Rinse’ label
l
One indelible ink pen for marking cable
l
Two 17” soak/rinse containers with caps
l
Two keys to safety door
l
One
Glute-Out®
Caddy with 5 sample bottles of
Glute-Out®
glycine based neutralizer
l
One Philips screwdriver
l
Laminated Probe Soaking Instructions (This
MUST
be placed above the workstation)
l
One Bottom support bracket
l
One filter installed in unit
Wall Mounting Instructions
1. You will need the following items before attempting to install this unit:
l
Measuring tape
l
Level
l
Pencil or pen
2. Install Bottom support bracket using 3 screws already attached to bottom of unit.
3. Location selection:
l
There must be a minimum of 4” of clearance on the left side (for switch and fuse access) and 2” on the
right side of the unit (for air flow).
4. Measure up from the floor to the top of the unit approx. 54 ½” (recommended) or to the comfort level of
the operator.
5. At that point, using a level, draw a line approximately 10” long. Mark two points on this line 8” apart.
CAUTION: Anchors should not be installed into wall studs.
M0046_H
4
G10VPL
GUS Disinfection Soak Station™
