5916 QolorFLEX 2x2.5A 2.4GHz Multiverse Dimmer
10
Dimmer tab
- Bump Buttons Enabled
- Apply to All: No
- Device Label: Default Dim 1 Label
- Curve Logarithmic (LED)
- Output Response Time 100ms Ramp Time
- Modulation Frequency 5000Hz-LED
- Control Offset 0
Multiverse Tab
- DMX Input Mode Wired
- SHoW ID 24250
- Antenna Selection Internal
- Output Power Max
- SHoW Key 0
Info
- DMX Fail Mode: Hold last look before changing to a level: Infinite
Hold level before blacking out: Infinite
Setup
To configure as a WIRED device using an RDM controller:
Start by connecting an XLR5M to bare end jumper to the DMX terminals of your 5916. Be
careful to maintain polarity. On the XLR connector
pin 1 = common, pin 2 = DMX “-“, pin 3 =
DMX “+”. Connect an RDM controller such as a City Theatrical DMXcat.
Using RDM, discover your 5916.
DMX Tab
- Enable or disable RDM traffic downstream of device
- Set DMX Port Label (user selectable name)
- Set Universe (must match between Transmitter and 5916)
- Set DMX Address
- DMX Personality (8 or 16 bit)
Dimmer Tab
- Enable or disable bump buttons
-
Select “Apply to All” to apply your choices to both Dimmers.
Note: This must be selected
before making any setting changes.
- Set Device Label (user selectable name)
- Select Dimmer Curve (changes the slope of the dimmer curve, see pg. 13 for all choices)
- Select Output Response Time (lengthens the dimmer response time to achieve smoother
dimming, see pg. 13 for all choices)
- Modulation Frequency (sets the dimming PWM to prevent interference or flickering with
film and video camera shutters, see pg. 13 for all choices)
- Set Control Offset (At very, very low levels in slow fades, the LED emitters may energize at
different times. If for instance you are using a bi-color tape, you can offset the time that
