Page 5 of 15
hopping limited to a section of the spectrum (including areas of the spectrum outside of
the Wi-Fi range), or adaptive hopping.
•
Protocols supported: ANSI E1.11 DMX512-A; E1.20 RDM
•
Built-in Multiverse 2.4GHz (for worldwide use) and 900MHz (for use in the
Americas only) Frequency Hopping Spread Spectrum radios
•
Compatible with all Multiverse and legacy SHoW DMX Neo products
•
User can select a single universe to receive
•
Four button user interface screen to set SHoW ID, universe, and other functions
•
RDM proxy and responder functions
•
DMX In (when used as transmitter) and Out (when used as receiver) via 3 pin
Screw Terminal
•
Rugged weatherproof aluminum enclosure
•
Antenna: Omni Broadband, 900MHz/2.4GHz, 2.5dBi/2.5dBi
•
User selectable transmit or receive mode
•
Firmware updateable via USB port
•
Power input 90-277VAC input, 1A max, on 3 pin screw terminals
•
User interface selection of DMX512 termination
•
Selectable display timeout and brightness level
•
A bracket for surface mounting or mounting from a pipe
Installation
Install the Multiverse Vero Transceiver in a suitable location, following the instructions below. For
best results the antennas in your system must be within sight of each other.
Warning
To avoid electric shock, do not energize any circuits before all internal and external electrical and
mechanical clearances are checked to assure that all assembled equipment functions safely and
properly.
Important use notes
This unit must be used with voltages below 600V. This unit must be installed in accordance with
the National Electrical Code, ANSI/NFPA 70, where the ambient temperature does not exceed
60°C maximum.
Grounding
This enclosure has been provided with a ground bond jumper for ground connection between the
back box and the cover. This jumper must be installed using the provided hardware.
Mounting Bracket
The provided mounting Bracket Base can be mounted on a surface or a vertical pipe. For surface
mounting, the Bracket base is provided with slots and holes suitable for #10 / M4 screws or similar
fasteners.
