®
7. Channel EQ Control ‘Hi’
This control 9dB boost and -26dB of cut to the high frequencies.
8. Channel EQ Control ‘Mid’
This control 9dB boost and -26dB of cut to the mid frequencies.
9. Channel EQ Control ‘Lo’
This control 9dB boost and -26dB of cut to the low frequencies.
10. Channel Fader
Input fader for control of the music program level.
11. Crossfader
45mm crossfader which can be changed easily and quickly via the two outside pozi screws and 5-
pin plug.
12. Headphone Level Control
Sets the desired music level to the headphones. The headphone program depends on the position
of the monitor pan control (13).
13. Headphone Mix (Pan) Control
Varies the mix between the cued input and master output, ideal for accurate beat mixing. Full left
will give cued input, full right will give master output program
.
14. Cue Selector Switch
These buttons are used to activate a channels “PFL” mode. A red LED next to the Cue button will
glow when a channels Cue mode is activated. Cue mode will send a channels incoming signal to
the headphones. The cue level is adjusted by the headphone level control (12). Be sure the cue
level is set to minimum before connecting a pair of headphones. Be sure the headphone pan
control (13) is turned to the “CUE” position to hear the selected channel source.
15. Master Output Control
This varies the level of mix output to the master output.
16. LED Monitor Display
The dual LED’s indicators are used to indicate the master output level.
Features & Functions Rear Panel
17. Power Switch
Use this switch to turn the power On/Off to the mixer.
Note: Be sure to switch on the power to your mixer before the amplification system.
18. AC Input
This connector is used to supply main power to the unit via the included AC adaptor.
19. Master Output
Main stereo program output provided by standard unbalanced RCA phono sockets:
Level
=
0dB
V
(
1
V)
Output Impedance
=
<
1K
Ohm
Load Impedance (MIN)
=
10
K Ohm