Citronic PRO-3:USB, Руководство пользователя

Страница: 7 / 10

6
25
26
This jack is used to a connect a microphone to the mixer. Connect you microphone via1/4
inch (6.3mm) jack. The signal volume will be controlled by the DJ MIC KNOB (1) . The bass
and treble levels can also be adjusted by the built-in MICROPHONE EQ (2/3).
This jack is used to connect your headphones to the mixer allowing you to monitor the cue
source. Use headphones only rated at 8 ohms to 32 ohms. Most DJ headphones are rated at
16 ohm, these are highly recommended. Always be sure the CUE LEVEL VOLUME (12)
is set to minimum before you put the headphones on.
25. DJ Microphone Jack
26. Headphone Output Jack
Due to fog residue, smoke, and dust, cleaning the mixer should be carried out periodically to
Optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2. Use a cleaner specially designed for electronics to spray in and around the knobs and witch.
This will reduce small particle built up that can effect the proper operation of the mixer.
3. Clean should be carried out every 30-60 days.
4. Always be sure to dry all parts completely before plugging the mixer in.
Cleaning frequency depends on the environment in which the mixer operates (i.e. Smoke,
fog , residue dust, dew).
Cleaning
NOTE:
(1)USB cable limit within 3 meter.
(2)To use the USB2.0 connection, please also refer to the operation manual of your
computer and the programmers used.
After