CT Active Speakers User Manual
Specifications
Model
CT8A
CT10A
CT12A
CT15A
CT15SA
Power supply
230Vac, 50Hz
Top hat
Base mounted 35mmØ
Top mount 35mmØ
Horn Driver
Titanium compression
N/A
Connector
XLRF input, XLRM output
Sensitivity
775mV
System
2-way full range
Sub woofer
THD
<0.04%
Woofer
20cm (8“)
25cm (10“)
30cm (12“)
38cm (15“)
38cm (15“)
Tweeter
2.5cm (1“)
2.5cm (1“)
4.4cm (1.75“)
4.4cm (1.75“)
N/A
Power rms
100W + 50W
100W + 50W
300W + 100W
300W + 100W
400W
Dispersion
90 x 60°
90 x 60°
50/100 x 55°
50/100 x 55°
N/A
Flying Points
6 x M6
6 x M6, 4 x M8
10 x M8
10 x M8
10 x M8
Frequency response : -3dB
65Hz - 18kHz
55Hz - 18kHz
50Hz - 18kHz
40Hz - 18kHz
40Hz - 250Hz
Frequency response : -
10dB
60Hz - 20kHz
50Hz - 20kHz
40Hz - 20kHz
35Hz - 20kHz
35Hz - 250Hz
Max. SPL
116dB
116dB
118dB
120dB
120dB
Dimensions
405 x 275 x 265mm 464 x 321 x 321mm
620 x 415 x 391mm
700 x 485 x 460mm
700 x 485 x 460mm
Weight
8.6kg
10.5kg
23kg
30.5kg
30.5kg
Troubleshooting
No power light on rear panel switch
Ensure IEC inlet is connected to mains and mains lead is in good condition
Ensure mains outlet is switched on
Check mains fuse. If repeatedly blowing, refer to qualified service personnel
Power light is on but no other LEDs and no output
Check input signal and connection leads
Ensure VOLUME, BASS and TREBLE controls are not turned fully down
Output very distorted and CLIP or LIMIT LED is lighting
Turn down the input level from audio source
If line input, ensure MIC/LINE switch is not pressed in
Turn down VOLUME, BASS and/or TREBLE controls
Output is working but at very low level
Ensure input source is at line level
If microphone input, ensure MIC/LINE switch is pressed in
Increase input level from audio source
Turn up VOLUME, TREBLE and/or BASS controls
Errors and omissions excepted.
Copyright© 2012. AVSL Group Ltd.
